Dual DS12 Bedienungsanleitung Seite 1

DS12HYDRAULICUTILITY SAWSAFETY, OPERATION AND MAINTENANCEUSER’S MANUALCopyright © 2009, The Stanley Works71069 11/2009 Ver 2Read the ManualWear your P

Oil Flow Hose Lengths Inside DiameterUSE(Press/Return)Min. Working PressureGPM LPM FEET METERS INCH MM PSI BARCertifi ed Non-Conductive Hose - Fiber Br

10HTMA REQUIREMENTSFLOW RATETOOL OPERATING PRESSURE(at the power supply outlet)SYSTEM RELIEF VALVE SETTING(at the power supply outlet)MAXIMUM BACK PRE

PREOPERATION PROCEDURESCHECK THE POWER SOURCE1. Using a calibrated fl ow meter and pressure gauge, make sure the hydraulic power source develops a fl ow

WHEN TO TENSIONAll chains have a tendency to stretch when used. Diamond chains stretch more than wood cutting chains because of the abrasive materials

CHECK THE WATER SUPPLY1. Always have water running before starting the chain saw.2. Recommended water fl ow 4 gpm/15 lpm at 50 psi/3.5 bar (2-gp/7.5 lp

TYPES OF CUTSThe DS12 can be operated not only using the pipe clamp but also make free-hand cuts, any size pipe can be cut free hand.Utility Chain Saw

TOOL EQUIPMENT & CARE• Make sure all couplers are wiped clean before connection.• The hydraulic circuit control valve must be in the “OFF” posit

CHAIN SAW TROUBLESHOOTING Excessive vibration and cuts rough. Loose chain tension. Retension the chain. Excessive feed force. Reduce feed force

CHAIN SAW TROUBLESHOOTING CONTINUED Chain saw cuts slow. Back pressure too high. Should not exceed 250 psi/17 bar @ 9 gpm/34 lpm measured at t

SPECIFICATIONSInput Flow Range ...

DS12 PARTS ILLUSTRATION19

20 58 71046 1 Drive Sprocket 59 20471 1 Trantorque® Adaptor 60 71051 1 Chain Guard 61 02766 2 Plain Washer 62 03276 2 Nut 63 22702 1

Utility Saw ClampInstruction SheetA potentially hazardous situation exists which, if notavoided, could result in death or serious injuryBefore cutting

Stanley Hydraulic Tools (hereinafter called “Stanley”), subject to the exceptions contained below, warrants new hydraulic tools for a period of one ye

Stanley Hydraulic Tools3810 SE Naef RoadMilwaukie OR 97267-5698503-659-5660FAX 503-652-1780www.stanleyhydraulic.com

TABLE OF CONTENTS3Safety Symbols and Precautions ...

CERTIFICATE OF CONFORMITY ÜBEREINSTIMMUNGS-ZERTIFIKATCERTIFICAT DE CONFORMITE CEECERTIFICADO DE CONFORMIDADCERTIFICATO DI CONFORMITA

4Safety symbols and signal words, as shown below, are used to emphasize all operator, maintenance and repair actions which, if not strictly followed,

Tool operators and maintenance personnel must always comply with the safety precautions given in this manual and on the stickers and tags attached to

• Always be well rested and mentally alert before operating the chain saw.• Do not allow bystanders near the chain saw when starting or cutting.

The safety tag (p/n 15875) at right is attached to the tool when shipped from the factory. Read and understand the safety instructions listed on this

8HOSE TYPESThe rated working pressure of the hydraulic hose must be equal to or higher than the relief valve setting on the hydraulic system. There ar